TH-M6 TEMPERATURE CONTROLLER, TH-M6 48 TEMPERATURE CONTROLLER

Operation
Key features:

• Synchronous heating of all the zones despite the different thermal inertia: the delay in the heating start of the nozzles is no more required.
• Autoslave in case of TC failure: each zone can be linked to another with similar thermal behaviour. This is a more accurate alternative to the open loop mode (manual mode)
• Plastic leakage alarm: with a continuous monitoring of the power consumption, the leakage from a nozzle is detected and major damage due to the plastic leakage can be avoided
• Collective modification: temperature setting and all the control and alarms parameters can be modified at once on all the zones by  pressing a button on the frontal panel
• Immediate and complete diagnostic: 6 led per zone indicate all the possible failures in the heating loop. In detail the controller recognizes and displays: thermocouple errors (breaking and inverted connection), fuse, heater and solid state relay faults, phase voltage missing
• 16 A max. per zone (3500 W) also contemporary, thanks to the high performance, self ventilated heat sink
• Heaters drying with single phase modulation
• Output powers are not synchronous in order to avoid peaks in power supply line
• 2 independent set points

In addition the TH-M6  controller has the following optional functions:

• Interconnection of  two temperature controllers: the connected zones will follow the same incremental temperature ramp
• Remote connection between serial port RS-485
• Digital inputs - outputs  for alarms and enabling control towards the press and others auxiliary devices