FN1T-AV TYPE FN1-AV: Nozzle suitable for moulding parts where good injection point vestige is required. It is suggested only if the injected material is EPDM, HDPE, LDPE, LLDPE, PP, PS. is not suitable for moulding materials with abrasive charges. TYPE FN1MDT-AV: Nozzle suitable for moulding parts where good injection point appearance is required. Unlike the FN-1T nozzle, it is suitable for moulding materials as EPDM, HDPE, LDPE, LLDPE, PP, PS with abrasive fillers. TYPE FT1MD-AV: Nozzle suitable for moulding parts where good injection point appearance is required. Unlike the FN-1MDT nozzle, is recommended for all other polymers also with abrasive fillers. Catalogue YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: Ø 16 Ø 24 Ø 32 Ø 46 Ø 60 nascosto
FN1D-AV TYPE FN1D: Nozzle suitable for moulding parts where good injection point appearance is required. The nozzle is suitable for moulding materials with abrasive fillers. Unlike to the FN-1T nozzle, the die can be machined to seal the nozzle from the mould cavity side. The circular witness mark of the tip will remain on the moulded part. Catalogue YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: Ø 16 Ø 24 Ø 32 Ø 46 Ø 60 nascosto