TYPE TF-1B50 TF/TF6-1B50 TYPE TF/TF6-1B50: Nozzle suitable for molding parts where good injection point appearance is required. Fitted with extended tip of 5 mm to be housed in areas where the space is limited. Suitable for molding thin parts that require fast cycles. Moreover, the heating area is distant from the surface of the piece to limit halos and imperfections on the molded piece. The nozzle is not suitable for molding materials with abrasive fillers and to perform quick colour changes. This nozzle is suitable mainly to inject polyolefin and polymers with high fluidity. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: