TYPE TF/TF6-2DSLA TYPE TF/TF6-2DSLA: The nozzle is suitable for moulding on sprues or directly in cavities, leaving a small sprue on the moulded piece. The die can be machined to seal the nozzle from the mould cavity side. With respect to the TF-2DSPR, the tip has been strengthened to allow the execution of larger sprues. The circular mark of the tip will remain on the moulded part. The nozzle is not suitable for moulding materials that tend to drool. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter:Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: