TYPE TF/TF6-2DSTD TYPE TF/TF6-2DSTD: The nozzle is suitable for moulding parts where good gate vestige is not required. The die can be machined to seal the nozzle from the mould cavity side. The circular mark of the tip will remain on the moulded part. For materials with high fluidity only. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: 2D/3D drawings download - Bushing YOU MUST FILL IN THE FIELD TYPE BUSHING Type Bushing: Nozzle bushing can be normal or conditioned. Select: Conditioned YOU MUST FILL IN THE FIELD BUSHING LENGTH Bushing Length: Conditioned bushing are without spacers and they are provided in 2 standard lenghts. Select