TYPE TF/MO-3B TYPE TF/MO-3B: This nozzle is suitable for moulding parts where a good gate aesthetics is required. It is provided with prolonged tip in order to be fitted in restricted areas. It is suitable for moulding thin wall parts which require fast cycles. The heating area is far from the part surface, to reduce halos and unsightly marks on the moulded part. The nozzle is suitable for moulding materials with abrasive fillers. Not suitable for materials as polycarbonate or similar. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: Pin valve gate: Conical gate and Cylindric gate Select: Cylindrical Conical