TYPE TD/TD6-1GLT TD-1GLT: Nozzle suitable for molding parts where appearance is of great importance. This particular tip shape allows for a uniform material distribution, therefore reducing flow paths. The application market of this nozzle is mostly cosmetics and packaging, where the appearance of the molded piece is very important. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: 2D/3D drawings download - Bushing YOU MUST FILL IN THE FIELD TYPE BUSHING Type Bushing: Nozzle bushing can be normal or conditioned. Select: Conditioned Not conditioned YOU MUST FILL IN THE FIELD BUSHING LENGTH Bushing Length: Conditioned bushing are without spacers and they are provided in 2 standard lenghts. Select: YOU MUST FILL IN THE FIELD SPACER HEIGHT Spacer Height: Spacers can be used when it is required to have a bushing longer than the standard ones. Spacers cannot be used with conditioned bushings. Select: