TYPE TD/TD6-1B TYPE TD/TD6-1B: Nozzle suitable for moulding parts where good injection point appearance is required. Fitted with extended tip of 3,5 mm to be housed in areas where the space is limited. Suitable for moulding thin parts that require fast cycles. Moreover, the heating area is distant from the surface of the piece to limit haloing and imperfections on the moulded piece. The nozzle is suitable for moulding materials with abrasive fillers but not to perform quick colour changes. For materials with very high fluidity only. If compared with TF series nozzles, TD nozzles have the sealing area on the external body rather than the tip and requires less accurate machining of the seat. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: