TYPE TF/TF6-1DSLU TYPE TF/TF6-1DSLU:The nozzle is suitable for moulding on sprues or directly in cavities, leaving a small sprue on the moulded piece. The nozzle is suitable for moulding materials with abrasive fillers. Unlike to the TF-1 nozzle, the machining of the die to seal can be carried out from the mould cavity side. The tip strengthened allows the execution of larger sprues. With the respect to the TF-1DSLA nozzle, the tip is longer and can be shaped to follow the profile of the moulded part. The circular witness mark of the tip will remain on the moulded part. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: