TYPE TF/MO-3DSLU TYPE TF/MO-3DSLU:The valve gate nozzle is suitable for moulding parts where an optimum gate aesthetics is required. It is also suitable for moulding materials with abrasive fillers. Unlike from the TF/MO-3 nozzle type the sealing area of the nozzle seat can be easily machined on the cavity side. With respect to the TF/MO-3D, the tip has been strengthened to allow the execution of larger sprues. With the respect to the TF/MO-3DSLA nozzle, the tip is longer and can be shaped to follow the profile of the moulded part. The circular witness mark of the tip will remain on the moulded part. Catalogue Multicavity nozzle Single nozzle YOU MUST FILL IN THE FIELD NOZZLE DIAMETER Nozzle diameter: Diameter of the nozzle seat Select: nascosto 2D/3D drawings download - Nozzle YOU MUST FILL IN THE FIELD HEATER YOU MUST FILL IN THE FIELD LENGTH Heater wire exit: Heater wire exit can be on the top or in the middle of the nozzle. Heater wire exit in the middle allows the replacement of heater whilst the mould is assembled on the injection device. Select: Nozzle length: Distance in the mould between the lower surface of the nozzle head and the injection gate. The gate is at the end of the nozzle and the beginning of the moulded piece. Select: 2D/3D drawings download - Bushing YOU MUST FILL IN THE FIELD TYPE BUSHING Type Bushing: Nozzle bushing can be normal or conditioned. Select: Conditioned YOU MUST FILL IN THE FIELD BUSHING LENGTH Bushing Length:Conditioned bushing are without spacers and they are provided in 2 standard lenghts. Select